Eksisterende pumpe - Afløp
Udskiftningspumpe Udskiftningblad
Produktinformation
TMW 32/11
Your advantages
- User-friendly – ergonomic handle, low weight, ready-to-plug version (Plug&Pump)
- Operationally reliable – stainless steel-encapsulated motor with sheath flow cooling, mechanical seal and sealing chamber
- Drain TMR with flat suction – minimal residual water level of 2 mm
Submersible drainage pump.
Application
Pumping of:
- Sewage without faeces or long-fibre constituents
- Wastewater
- Connection cable with plug
- Float switch
- Self-switching thermal motor monitoring
- Sheath current cooling
- Pump with connection cable and plug
- Fitted float switch (apart from TM 32/8-10)
- Threaded connection with non-return valve (Drain TMW/TMR)
- Hose connection, supplied (Drain TM)
- Installation and operating instructions
- 10M: 10 m connection cable
- 30M: 30 m connection cable
- Mains connection 1~ 230 V, 50 Hz
- Protection class: IP68
- Max. immersion depth:
- 4 m cable length: 1 m
- 10 m cable length: 4 m
- Fluid temperature: 3 ... 35 °C, briefly up to 3 min.: max. 90 °C
- Pressure port:
- Drain TM: G 1¼male
- Drain TMW/TMR: G 1¼female
TM/TMW/TMR:
- Motor housing 1.4301(AISI 304)
- Pump housing: PP-GF30
- Impeller: PPE/PS-GF20
- Shaft: 1.4104 (AISI 430F)
- On motor side: NBR
- Fluid side: Carbon/ceramic
- Motor housing 1.4404 (AISI 316L)
- Pump housing: PP-GF30
- Impeller: PPE/PS-GF20
- Shaft: 1.4404 (AISI 316L)
- On motor side: NBR
- Fluid side: Carbon/ceramic
Submersible pump for stationary and portable wet-well installation in fully automatic mode with attached float switch.
Hydraulics
The pumps are equipped with an open multi-vane impeller and have a free ball passage of 10 mm (TM/TMW) or 2 mm (TMR). The pressure connection is a vertical hose connection (TM) or threaded connection (TMW/TMR).
Motor
Sheath flow-cooled single-phase AC motor with integrated operating capacitor. The motor heat is transferred directly to the fluid via the motor housing.
The motor is equipped with automatic thermal motor monitoring. This means that the motor is switched off if it overheats and will be automatically switched on again once it has cooled down.
Seal
The seal is created on the fluid side by a mechanical seal, and on the motor side by a rotary shaft seal. A sealing chamber with a white-oil filling is located between the gaskets.
Cable
The pump is equipped with a 4 or 10 m long connection cable with a shockproof plug and a fitted float switch (not TM 32/8-10M).
Versions
- Drain TMW with twister function - The twister function guarantees permanent turbulence within the pump's intake area. This prevents settling sediment from sinking and settling. This results in a clean pump sump and reduces the build-up of odours
- Drain TMR with flat suction - The special strainer enables the fluid to be pumped out to a remaining level of 2 mm.
Switching points: up ON / down OFF
Switching points: up ON / down OFF
Switching points: up ON / down OFF